Phone Status Icon
Chat Icon
(800) 285-7995 Support | Live Support Chat
  1. Home
  2. Nextiva Voice
  3. Nextiva Office
  4. How to Add a Polycom VVX 300
  1. Home
  2. Nextiva Voice
  3. How to Add a Polycom VVX 300
  1. Home
  2. Phones & Networking
  3. How to Add a Polycom VVX 300

How to Add a Polycom VVX 300

When setting up a new device on your Nextiva account, the first two steps are to Add a Device and Create Employees.

Be sure to complete these steps before provisioning your phone(s). If you purchased your new phone(s) directly from Nextiva, you are all set! You should now be able to make a test call.

If you did not purchase your phone(s) from Nextiva, please follow these setup steps.

How to set up a Polycom VVX 300 from the Nextiva Portal:

  1. To start, reboot the phone (or unplug it and plug it back in). You’ll see a 10 second countdown timer displayed on the phone after reboot.
  2. Press the Setup key when it is displayed on the screen.
  3. You will be prompted to enter a password. The default password is 456.
  4. Scroll down to Server Menu and press Select.
  5. Edit the Server Type and change it to HTTP using the left and right arrows on the phone. Select OK.
  6. Edit the Server Address and change it to
    • Important Note: The Server Address is case sensitive and has to match up precisely with the server URL (
    • There is a key labeled a/A/1 on the screen that can be used to alternate between lowercase/uppercase/numbers.
    • The asterisk (*) key is used for periods.
    • The pound (#) key is used for forward slashes (/), underscores (_), and dashes (-).
  7. When you finish entering the URL, press OK. Press Back and scroll down to select Tag SL to UA. Set this to Enabled and press OK.
  8. Press Exit twice, then Save, and Reboot. Please allow a few minutes for the device to reboot.
  9. Note: The phone will attempt to boot up and configure to the settings of the employee assigned to the phone. Please allow a few minutes. If the phone displays the error “Could not contact boot server”, it is important to check that the correct MAC Address is assigned to the employee by logging in to the NextOS Portal. Also, be sure the Server Address was entered exactly as directed above. Having a capital letter or a missing character can cause the phone to not connect properly.

Updated on December 28, 2016

Was this article helpful?